increases: kfb and m1
making stitches out of nothing·4 min read·+30 xp· unlocks after 2.4
1kfb: front, then back
knit the stitch but don't slide it off; knit into its back leg too, then slide. one becomes two, with a tiny bar.
2m1: lift the strand
find the strand between two stitches, lift it onto the left needle, and knit into its back. into the front leaves a hole.
an increase makes a stitch where there was none. two are enough for now: kfb is easy and leaves a little bar; m1 is nearly invisible.
kfb: knit front and back
- knit the stitch as usual but do not slide it off.
- swing the right needle round to the back of the same stitch and knit into the back leg.
- now slide it off. one stitch became two. the second one has a purl bump beside it, which is the tell.
m1: make one
- find the horizontal strand of yarn running between the stitch you just worked and the next one.
- lift it onto the left needle with the tip, from front to back.
- knit into the back of it. knitting into the front would leave a hole. (that is m1L; m1R lifts from back to front and knits the front. they lean opposite ways and a pattern will tell you which.)
the triangle
cast on three and kfb at the start of every other row. the fabric grows into a triangle with a clean edge and the tiny bars marching up one side. that is the same move a top-down sweater uses to grow the yoke, just smaller.
the tell
count after every increase row. if a hole appeared at an m1, you knit into the front of the lifted strand.
knit the swatch · written by the math, not the model
triangleCast on 3 sts using the knitted cast-on.3 stsRow 1: knit.3 stsRow 2: kfb, knit to end.4 stsRow 3: knit.4 stsRow 4: kfb, knit to end.5 stsRow 5: knit.5 stsRow 6: kfb, knit to end.6 stsRows 7–20: keep going, kfb on every even row, knit every odd row, until you have 13 sts.13 stsBind off. You made a triangle out of one line of instructions.