sign in
← all lessons
level 1 · lesson 5

bind off + weave in the ends

finishing, the first time·3 min read·+20 xp· unlocks after 1.4
1knit two

knit two stitches the usual way, so two sit on the right needle.

2lift the first over
over, and off

with the left needle tip, lift the first stitch over the second and off the end. one stays.

3last loop
pull the tail through

knit one more, lift again, until one loop is left. cut the yarn and pull the tail through it.

binding off is how you take the fabric off the needle without it unravelling. it is two knit stitches and a hop.

the bind-off

  1. knit two stitches the normal way. two stitches on the right needle.
  2. with the left needle tip, lift the first stitch (the one further from the tip) up and over the second, and off the needle. one stitch left on the right needle.
  3. knit one more, so there are two again. lift the first over the second. repeat to the end.
  4. one loop is left. cut the yarn leaving a hand's length, pull the tail through the loop, tug.

loosely

everyone binds off too tight the first time and gets an edge that curves like a smile. knit the bind-off stitches on the fat part of the needle and let the loops stay big. if the edge is still tight, bind off with a needle two sizes up.

weaving in

thread the tail on the tapestry needle. on the back of the fabric, follow a ridge for six stitches, then turn and go back three. trim, leaving a few millimetres. the end will felt itself in with wear.

the coaster

eighteen stitches, thirty rows, bind off, weave in two tails. put your mug on it. you have finished your first object, and it took about forty minutes.

knit the swatch · written by the math, not the model
coasterCast on 18 sts using the knitted cast-on.18 stsRows 1–30: knit.18 stsBind off loosely. Weave the tails in along a ridge, six stitches each way, and trim.
18 sts30 rows
+20 xpcheck it off when the swatch is off the needles.